Key Assignments Short List

Running keys

S&P Keys

F1 = CQ
; or insert = Send call and report
'  = Send TU message and enter in log

Alt+R = Enable CQ repeat
Ctrl+R = Set repeat time

Esc = Stop sending, stop repeat

Shift+F1 = Call CQ and switch to run
Alt+U = Toggle S&P/Run. Set CQ-frequency for pass
Alt+Q = Return to CQ-frequency

Ctrl+Up/Dn arrow = Grab next qso from bandmap
Alt+Ctrl+Up/Dn arrow = Grab next mult from bandmap

Ctrl+O = Set operator call (or OPON in Callsign field)
Ctrl+N = Add note to log

Ctrl+W or Alt+W = Wipe entry fields
                              Release a reserved serial number

SPACE or Tab = Move between logging fields
Enter = Log it (see ESM mode)

Ctrl+Q/A = Quick edit previous or next call
Ctrl+D = Delete last qso!

Alt+H = Show help
Alt+K = Edit message buttons
Alt+Ctrl+Enter = Log a not accepted 'invalid' qso.

Alt-F10 = Swap VFOs
Alt+Q = Return to CQ frequency
Alt+F8 = Return to last frequency

Ctrl+PgUp/PgDn = Up/Down a band
Type CW/USB/LSB/RTTY= Change mode

Ctrl+S = Set radio into split   Ctrl-Alt-S - Toggle split mode
Ctrl+Enter = Set split frequency
Alt+F7 = Set split frequency or offset to specified frequency
Alt+'   = Toggle between the wide and narrow filters
Alt+F12 - Copy frequency and mode to other radio/VFO.
        or swaps MAIN and SUB using the CAT radio command

Backslash ( \ ) = Change Receive (RX) focus (VFO/Radio)

Mouse wheel = Zoom in/out bandmap
Keypad +/- = Zoom in/out bandmap
Alt+D = Remove spot

Alt+P = Send spot
Ctrl+P = Send spot with comment
Ctrl+Tab = Toggle to/from packet window

Alt+O = Store contact in the Bandmap

Alt+Q = Jumps to the CQ frequency on this band

Ctrl+M = Turn on/off
Insert or ; = Send call and exchange
Enter = Send TU and log it
Enter = Start CQ again...
Alt+Enter = Log without sending anything

Multi-User Mode

Alt+Z = Set pass frequency (broadcasted to all computers)

Backslash ( \ ) - Two radios = Change Receive (RX) focus
Pause = Swap both Transmit and Receive/Keyboard focus

Ctrl+Enter = Send next ESM state on alternate radio
Ctrl+F1 to F12 = Send message on alternate radio
Ctrl+B = Dueling CQ's
` (Back-quote) = Toggle Stereo/Mono ( LPT pin 5).
Ctrl+I - Toggle through SO2R supported modes ($5SO2R)

FT-1000MP + FT1000D + some Icom Dual Watch radios
Alt+F12 = Dual Receive toggle

TenTec Orion
Alt+F12 = Toggle Main/left Sub/Right and Active in both ears.

Rotor control for the callsign in the Entry window.
Alt+J - Turn rotor to bearing
Alt+L - Turn rotor to long path bearing
Ctrl+Alt+J - Stop turning the rotor

Ctrl+Shift+F1 =
         Record CQ 
Ctrl+Shift+F* =
       Record F-key message
NB. Same keys again to 
      stop recording

Alt+G = Grab call from stack
Alt+T = RX/TX toggle
Ctrl+Arrows = Swaps DI
Esc = Stop sending